Top Shelf Ultrasonic Water Level Meter With LED Digital Display, 4-20mA And RS485 Output For Reliable Liquid Measurement, DC24V Power, 8 Meter Range, The Real Deal Transmitter That Gets The Job Done Fast
✔️ 24V covers 8m depth with LED screen plus 4-20mA and RS485 links
You get a reliable single sensor unit built for consistent tank monitoring and industrial fluid tracking. This ultrasonic water level meter mounts directly above your liquid surface and sends steady sound waves down to calculate exact depths. You can drop it right into sump pits, chemical storage drums, or irrigation ponds where you need honest readings without manual dipping. The whole setup runs handy in factories or outdoor sites where steady data keeps your pump cycles on track.
✅ DC24V power input handles tough industrial environments while keeping your wiring board safe from sudden voltage drops.✅ Eight meter scanning range reaches deep reservoirs and tall holding tanks without losing signal clarity across dirty surfaces.
✅ Bright LED digital display gives you instant height readings straight away on site without extra software downloads.
✅ Dual signal outputs let your existing PLCs or data loggers grab measurements fast and sync perfectly with older controllers.
💡 What steps do you take to connect a precision liquid depth monitor to a factory control system?
Hooking up your ultrasonic tank gauge follows standard wiring routines that any technician can master in under ten minutes.
- You feed 24 volts DC directly into the main power terminals to keep the internal circuitry running cool and steady.
- You link the 4-20mA analog cables to your programmable logic controller for instant proportional level tracking.
- You plug the RS485 data leads into your remote monitoring panel so you can read storage heights handy from anywhere.
- You angle the fixed sensing head toward the liquid surface and verify the safety margin stays clear of splashing pipes.