Top Shelf 68 Cm Heavy Duty Industrial Electric Floor And Wall Mount Cooling Fan With Killer Quiet Motor And Rugged Safety Mesh Guard Built Tough To Keep Your Space Chill During That Daily Grind
✔️ Single unit packing plus 230W Driver 120 Degree Sweep
This heavy duty 68 cm industrial cooling fan brings serious air movement to your workshop or warehouse. The sealed package ships as a single floor or wall mount unit built for the daily grind. You get a rugged safety cage, three selectable wind speeds, and an internal thermal cutoff to keep operations running smooth during long shifts in garages, restaurants, or commercial kitchens.
✅ 68 cm titanium magnesium alloy blades push steady air✅ 230 watt dual bearing copper driver keeps operating temp down
✅ Horizontal tilt covers 120 degrees side to side sweep
✅ Safety thermostat trips at 145 celsius to protect internal wiring
✅ Reinforced bracket locks tight to drywall or solid masonry
Six meter throw clears open shop floors without fighting drafts
| Mount Mode | Total Height | Air Reach | Power Rating |
|---|---|---|---|
| Floor Stand | 140 cm | Approx 9 m | 230 Watts |
| Wall Bracket | 70 cm | Approx 9 m | 230 Watts |
| Blade Diameter | 68 cm | ||
| Longueur du câble | 3 meters | ||
💡 How do you match industrial fan rotation speed to actual room volume?
Dialing in the right move pattern comes down to matching blade pitch with available square footage. This sixty eight centimeter model is a handy upgrade for tough commercial layouts where basic office desks quit early. Break your setup routine down into these quick checkpoints:
- measure cross sectional width first then set the mechanical rotary dial to stage one before stepping up to full blast
- verify that your mounting holes drill straight through wood studs without cracking the outer plastic shroud
- route the thick shielded lead away from hot exhaust vents so rubber insulation stays intact during summer shifts
- tighten the base plate bolts clockwise until the vibration dampeners sit flush and stop the shaking dead