Rock Solid Table Saw Featherboard Replacement For 71553 Fence Keeps Timber Dead Nuts Secure Pack Of 2 Orange Polymer Workpiece Clamp Mounts With Height Adjustment Knobs And Hex Hardware

Pack of two orange polymer featherboard clamp mounts for saws
✔️ 3/8 by 3/4 by 7-1/2 inch poly mounts with two inch adjustment

These orange polymer workpiece clamps replace worn out fence brackets on saws and routing gear. They slide onto standard four by twenty inch table saw rails and miter guide tracks to lock lumber tight while you cut. The ribbed grip holds boards flat against the fence without damaging soft timber or hardwood stock. You get two units in every pack so you can set up dual stop stations across the shop floor.

✅ Thicker three eighth inch plate slides into standard t slot grooves
✅ Chunky three quarter inch width pushes boards straight through cuts
✅ Seven half inch long arm keeps hands clear of spinning saw blades
✅ Twist up knob secures position from ten to fifty degree angles

💡 What stops plywood and hardwood from walking off the fence board during aggressive pass
Most builders ditch steel brackets because they rust out fast and leave scratches on nice maple. A handy polymer setup keeps timber dead nuts secured without marring your stock. These replacements handle daily abuse on heavy machinery while staying lightweight and quiet during loud kickback moments.
- Heavy molded compound handles heat stress around burning blade teeth
- Slides smooth inside standard sixty four millimeter fence channels
- Replaces stripped factory grips without losing original thread pitch
- Snags less dust buildup compared to flimsy spring loaded toggles

✝️