Noteflora 3/4 Inch Conduit Bender And Pipe Bending Tool With Ergonomic Grip. Ideal For Water, Gas Line, Electrical Installation. Durable Carbon Steel Hand Bender Head For Stable, Long-Lasting Manual Tube Bending Tasks On The Job Site.
✔️ One-piece carbon steel jaw grips 19 mm rod fast without flex
This single-pack bender is a handy handheld device plumbers and electricians grab to shape copper, aluminum, and galvanized steel pipe right on the roof or basement floor. The gear head locks onto nineteen millimeter (three quarters inch) stock for tight home runs, while the wider jaw slots accept sixty-four millimeter (two and a half inch) tubing for commercial main lines. You drive the heel over the edge, roll forward, and watch the metal form a smooth arc that keeps wastewater flowing freely. The complete tool ships as a lone unit so you can clip it into your seat pocket and start bending on arrival.
✅ Quenched alloy shoe stays flat and refuses to warp under constant torque✅ Rubber molded sleeve absorbs palm vibration so you dodge blisters early
✅ Front clearance window measures nine millimeter (three eighths inch) to slide wire harnesses right through
✅ Stamped angle ticks run from zero to ninety-five degrees for instant reference
💡 How do you stop the metal wall from flattening out when you crimp down hard on a radius bender?
- Press the handle down at a slow forty-degree angle so the material peels evenly across the flange
- Keep one foot planted on the rear crossbar to kill upward bounce that splits the seam
- Lubricate the contact zone with a little spray oil if the gauge jumps above eleven millimeter (seven eighths inch)
- Reset the tube backwards a quarter turn and give it a final light pass to round out the ridge