Lochen Electric Hydraulic Rebar Bender 1700W Bends Grade 60 Steel Rods Up To One Inch Fast Foot Pedal Operation Desktop Design For Precise Angles Quick Heavy Duty Construction Tool

Single Electric Hydraulic Rebar Bender For Steel Rods
✔️ 1700W motor bends up to one inch or twenty five millimeter rods

This single unit tackles steel bar shaping on active job sites and backyard workshops alike. You get consistent results for fence frames, concrete forms, and structural ties without breaking a sweat.

✅ Cuts cycle time down to just three point five seconds per bend
✅ Accepts six to nine millimeter inserts for thin wire work
✅ Runs quiet at ninety two decibels while keeping torque constant
✅ Safety interlock stops power immediately if knobs clash positions
✅ Built in lift lugs and molded edges make loading trailer easy
✅ Matches carbon steel rounds and standard ribbed thread patterns

💡 How does an electric hydraulic rebar bender maintain tight tolerances on grade sixty reinforcement bars during continuous runs?
A handy drive system locks the angle so your prints stay dead on.
- 1700 watt copper windings push through cold work without stalling
- Anti slip rubber rollers bite into ribs and hold radius steady
- Foot pedal release frees both hands for positioning every cut piece
- Dual rail guide tracks prevent drift when flipping direction quickly

✝️