Heavy Duty Universal BGA Reballing Stencil Kit With Solid Metal Holders And Zero Sweat Solder Masks Perfect For DDR1 DDR2 DDR3 Chip Fixes Straight On Your Workbench

BGA reballing kit ships 13 pieces for DDR chip repair work
✔️ Twelve steel stencils with steel base for 0.45 mm solder filling tasks

This handy setup helps techs strip old solder off chips and drop fresh balls back onto landing pads. You typically run it right on your workbench when pulling damaged RAM sticks or swapping fried graphics cards from laptops and desktop towers. The whole frame measures 6.7 by 1.5 by 2.7 cm or 2.64 by 0.59 by 1.06 inches wide overall.

✅ stainless steel stencil matrix holds twelve exact templates for consistent board contact
✅ built to handle DDR1 DDR2 DDR3 modules plus desktop GPU memory swaps seamlessly
✅ designed around zero sweat solder masks to keep flux off your hands during quick fixes

💡 How do technicians prevent pad damage and leftover residue when stripping memory chips?
This method keeps your landing pads flat so new balls drop straight into hole without bridging.
- Control your hot air gun temp just over the alloy melt point to lift the old mask cleanly
- Scrape gently with a flat spudger to lift gunk without scratching the copper traces underneath
- Swab dry with high purity alcohol right after heating so flux clears out faster than usual
- Drop the fresh spheres through the guide while the board stays warm enough for perfect seating

✝️