Heavy Duty Hydraulic Gear Puller With Adjustable Two Or Three Jaw Setup For Bearing Replacement Crafted From Solid Forged Steel Components 50 Ton Hub Extractor Built Like A Tank For Everyday Shop And Garage Work

Heavy Duty Hydraulic Bearing Puller For Shop Repair Work
✔️ Thirty ton cap two point seven inch throw handles dual triple grip setups

This single hydraulic bearing removal kit extracts stubborn wheels hubs gears and pulleys from rusted shafts daily. Local mechanics run this setup in neighborhood yards and commercial bays to swap shot drum bearings haul fat flywheels or crack open seized steering knuckles without marring adjacent panels.

✅ Maximum tension holds thirty tons pushing through seized assemblies
✅ Piston travel measures two point seven inches seven hundred millimeters deep
✅ Full span opens fifteen point seven inches four hundred millimeters wide
✅ Hookback pulls nine point eight inches two hundred fifty millimeters back
✅ Rearrange grip points to dual leg or triplet stance for different loads

💡 What maintenance gear grabs stuck transmission flanges out of tight differential housings safely?

You can attach this hydraulic bearing removal tool to a floor pump handle and move heavy axles fast.

- One thick forged arm takes serious stress without flexing under hard loads

- Flip between two leg or three leg layout depending on whether you want maximum leverage or steady center pull

- Add light grease to sliding surfaces before hauling big truck components off the chassis

- Keep spare seals handy since repeated gear swaps eat up old housing bores over time