Heavy Duty Hydraulic Gear Puller Machine 15 Ton 33000 Lbs Bearing Hub Separator With Adjustable Two Or Three Jaw Arms Built Tough For The Garage Shop Grade Workhorse Crushes Rusted Parts Without A Sweat Works Vertical Or Horizontal
✔️ 15 ton load rating, 2 inch piston stroke, dual triple jaw setup
This hydraulic gear puller machine acts as a heavy duty bearing hub separator designed for tough garage and shop jobs. You can run it flat on a workbench or standing upright since the pump head spins a full 360 degrees. The built in one piece cylinder resists leaks and handles rusted pulleys, flywheels, flanges, and steering wheel hubs without missing a beat.
✅ Clear threaded push rod gives 2 inch by 50 mm pulling stroke for fast extraction✅ Adjustable reach hits up to 7 inches by 180 mm to grab deep seated bearings
✅ Max span opens wide to 11.8 inches by 300 mm for large diameter hubs and pulleys
✅ Swap between two or three arm configurations depending on the job scope
✅ One piece cast pump body eliminates leak points and holds pressure firmly
💡 Why go hydraulic instead of hand pumping when you want a handy solution for busted automotive assemblies?
Hydraulic pressure transfer delivers smooth traction that keeps stubborn shafts sliding off without warping thin metal walls.
- Mechanical advantage cuts down labor time while protecting delicate bearing races and mating surfaces
- Built in relief valves prevent overpressurizing thin housing walls during heavy extraction tasks
- Consistent piston travel maintains control when working with seized automotive or industrial assemblies