Heavy Duty Hydraulic Gear Puller Kit And Wheel Bearing Separator Built Tough With 2 Or 3 Jaw Design Vertical And Horizontal Garage Staple For Sprockets Rotors Axles

Single pack hydraulic gear puller kit for shop repairs
✔️ 10 ton lifting force with adjustable jaw setups for axles

Included as a single pack, this robust gear separator pulls stubborn wheel bearings, sprockets, and axle hubs off vehicle frames. Mechanics grab this unit when regular pullers slide off grease filled surfaces, since this model holds tight on round shafts and flat mounting plates alike. The cast iron pump housing and heat treated teeth handle daily garage abuse without bending or leaking fluid.

✅ High carbon steel cylinder resists cracking under heavy loads
✅ Dual or triple threaded legs adapt to different hub diameters fast
✅ Rotating pump cap clears tight clearance around transmission cases
✅ Horizontal reach spans two hundred fifty millimeters and nine point eight inches for wide grapples
✅ Vertical draw covers one hundred sixty millimeters and six point three inches for narrow frames
✅ Push rod extends fifty millimeters and two inches to bypass shallow bearing pockets

💡 Why choose hydraulic pull kits over manual extractor tools?
The extra pumping force tackles seized tolerances that freeze standard sliders. Here is how to run it safely:
- Match thread pitch to the inner race gap before starting extraction cycles
- Align jaws squarely to distribute pressure across thick mounting rims
- Apply fluid steadily to avoid sudden component drops during release

✝️