Fresh X Axis Limit Switch Replacement For Creality Sparkyi7 3D Printer Extruder Pcb Module With Cable Quick Auto Homing Reset After Power Blip No Sweat Drop In Upgrade Pack Of Two

Prix régulier $49.99 Prix de vente$100.00vous économisez 50,01
UPC:





Solid X Axis Limit Switch Pack Of Two For Creality Fix Ups
✔️ Two pre-routed trigger modules built for stable origin locking

You will get a direct drop-in upgrade for your Creality Sparky I7 setup. These X limit switches replace worn microtriggers that cause lost coordinates or failed print starts. You mount them along the left rail to lock down your starting point before every layer. The set fits inside standard DIY repair kits and keeps your build volume consistent across long runs.

✅ Normally open signal design stops the motor when triggered
✅ Attached routing cable protects wire from timing belt friction
✅ Light bracket clearance allows easy lever bounce and clean resets
✅ Factory preset travel range blocks guide rail damage during errors

💡 Why do handy X axis limit switch replacements matter for reliable 3D printer homing routines?
Missing zero points happen when board memory clears mid-job.
You can fix this quick hitch by wiring a fresh trigger.
- Send a homing command to tap the new lever and reset axes
- Adjust mounting screws until the lever flips at the exact touchpoint
- Set soft travel limits in firmware to block nozzle from hitting the frame edge
Proper triggering saves filament waste and locks your dimensions tighter than before.

✝️