Fresh Cut Heavy Duty Carburetor Choke Pull Off Actuator With Road Ready Build For Chevrolet K10 Engine Service And Tune Ups Genuine Quality Aftermarket Parts

Heavy Duty Carburetor Choke Pull Off For Chevy K10 Repair
✔️ WVE 1C1108 replacement actuator for K10 carburetor intake

This handy pull off valve regulates base airflow while your engine warms up. Mount it directly to the carburetor body on vintage K10 trucks to keep idles steady.

✅ Direct replacement for WVE 1C1108 stock unit on factory carbs
✅ Cross compatible with BWD VC642 and GM numbers 17079964 plus 17079980
✅ Built to hold tight seals under heavy vibration and heat cycles
✅ Matches exact mounting tabs and pushrod length for clean installs

💡 Why does my truck stall when pulling away from traffic light stops?

A failing pull off actuator cuts base air too fast during cold starts. Fixing this leaves your mixtures balanced once the motor warms. Here is how to pick the right swap job:
- Verify the factory bracket holes for rust that blocks clean mounting
- Compare the push rod travel against the factory stroke spec closely
- Inspect the internal diaphragm for leaks that starve idle jets
- Test the thermal switch operation with a simple multimeter before install

✝️