Ultimate OBD2 to USB C Adapter Hardwire Kit for Dash Cameras, Featuring Low Voltage Protection at 11.6V and 23.4V, Dual Mode Switch for Non-Stop 24/7 Parking and ACC Recording, Keeping Your Ride's Battery Safe and Providing Constant Power for Epic

Single-pack OBD2 to USB-C dash cam hardwire kit
✔️ 3.5 m OBD cable, 11.6V/23.4V cutoff, 6 protection

Tap power directly from the vehicle's OBD-II port with a plug-and-play hardwire kit that runs a Type-C dash cam, enabling 24/7 parking surveillance while shielding your battery. The setup supports 12V and 24V systems and keeps your camera fed without tying up the 12V socket. Cable length is 3.5 m (3500 mm) / 11.5 ft (139 in) for tidy, hidden routing in most cars.

✅ 6-in-1 circuit protection: Low Voltage Cut-off, Anti-Drain Protection, Over-Current, Short-Circuit, Reverse Polarity, Overheat Protection
✅ Stable 5V/3A output to dash cam, protecting against ignition surges and enabling post-park evidence
✅ Direct OBD power with data isolation from the vehicle ECU for safe, clean wiring
✅ Dual mode switch: ACC mode auto-off or 24/7 parking mode for constant recording
✅ Low voltage auto-cutoff at 11.6V (12V) / 23.4V (24V) to avoid dead battery
✅ 3.5 m cable length, compatible with most 12V/24V vehicles and Type-C dash cams
✅ Plug-and-play, no drilling; hides wires under trim for a clean look
✅ Works with A5-B5 pin definition; note not compatible with A8-B8 pins✝️

💡 What is an OBD power hardwire kit used for in dash cameras?

This handy setup keeps your dash cam powered during parking while protecting the car battery and avoiding ECU interference.

- Provides continuous power to dash cameras via the OBD-II port for ongoing recording
- Auto-cutoff maintains battery health by stopping power at safe voltages
- Enables parking surveillance and ACC recording for security evidence
- Simple, tool-free installation with hidden wiring for a neat install