Straight Up Heavy Duty Quarter Turn Fasteners With Five Sixteen Inch Shank Zinc Plated Steel Slotted Drive Self Ejecting Mechanism Race Ready Built Tough For Street Racing Or Weekend Garage Mods

10 Pack Heavy Duty Quarter Turn Fasteners For Race Panels
✔️ 5/16 shank zinc steel slotted self ejecting flush head latch

This set of 10 quarter turn fasteners lock side panels, hood vents, and air ducts tight on street machines and strip racers. You push the stem through a drilled hole and spin a slotted head to clamp it down. Track crews grab zinc coated steel bodies because they resist grinding dust and survive bumpy haulers. Swap old wear clips off for fresh ones in seconds. Other diameters sell separate online. Just pop them in, twist once, and leave the shop. Match the washer flange under the panel to stop rattling noises during highway runs. Grease the threads lightly before final tightening to guarantee smooth removal next time.

✅ Set comes with ten matching nuts and springs ready go
✅ Flat head sits flush so wide body kits clear bumpers clean
✅ Zinc finish blocks road salt and keeps threads spinning smooth

💡 Does the yield strength of a quarter turn latch affect clamping stability?

These sturdy latches save wrench time when swapping fenders between sessions. - Hardened center pin locks tight against frame rail flex - Thread pitch prevents loosening after fifty thousand RPM spins - Flush top edge stops sharp burrs from tearing driver gloves ✝️