Rugged Steel Clamshell Differential Carrier And Pinion Bearing Puller Fits Dana 30 40 60 70 80 And Ford 88 975 1025 Inches Snaps Right Out In The Shop

Heavy duty steel differential bearing puller tool
✔️ Works on Dana 30 40 60 70 80 and Ford 8.8 9.75 10.25 inch axles

You need a solid way to pull stubborn carrier bearings off hard rear axles. This single clamshell bearing puller handles that task without marring your axle tube. You slide it into place behind the differential cover and tighten the center screw to lift the old part straight out.

✅ Forged steel body resists bending under heavy torque loads during tough pulls.
✅ Even force distribution from the clamshell shape protects your pinion seals.
✅ Quick setup saves shop time by matching multiple axle housings directly.
✅ Smooth operation keeps your gear work moving fast without extra strain.

💡 Why is a tough bearing puller handy for removing sealed differential units?
Using proper leverage prevents scoring inner races while you swap out worn gears.
- Centered threaded rods apply direct axial force along the shaft line
- Curved clamp arms secure firmly over thick flange edges during stress
- High tensile steel construction withstands repeated heavy shop usage easily
You get clean removal cycles every time you tackle a rear end rebuild.

✝️