Rugged Dividing Head With Three Jaw Chuck Set For Milling Machines Featuring Four To Eight Inch Rotary Table And One Ninety Reduction Ratio Built Tough For Kickass Workshop Precision Cutting

Single Set Heavy Duty Indexing Head With 3Jaw Chuck
✔️ 1:90 ratio cast iron body mounts tables measuring up to 200mm

This dividing head upgrades your workshop mill or drill press setup by locking down accurate rotary spacing for repeatable cuts. You bolt it right onto your benchplate to handle gear cutting, angular drilling, and precise material division without wrestling with loose alignment tools. The solid build stays calm under heavy loads while you run consistent patterns across steel or aluminum blanks.

✅ Direct indexing plate swaps out quickly for different slot quantities
✅ Adjustable headstock tilts handy from ten below flat to full vertical rise
✅ Tailstock bracket locks securely onto longer rounds for steady support
✅ Wide jaw spread grips bars straight from two up to two hundred millimeters

Center Height	Chuck Size	Clamp Range	Total Weight
100mm / 3.9in	4in / 100mm	2mm-80mm / 0.07in-3.1in	22kg / 48.5lb
128mm / 5in	8in / 200mm	4mm-200mm / 0.15in-7.8in	50kg / 110lb

💡 Why is a manual rotary dividing head preferred over direct indexing for custom fabrication?

A precision gearing system guarantees repeatable angular placement so shop operators dodge layout mistakes when splitting complex curves.

- Exact degree offsets save bare metal during prototyping spiral stair risers or cam lobe outlines

- Rigid housing kills chatter vibrations when pushing hard feed rates through medium carbon steel

- Handy tilt mechanisms cut down fixture swaps when tackling steep ramping paths on CNC routers

✝️