Ready To Roll Slick Fit Bellows Rubber Boot Replacement For W Rammer BS500 BS50-2 BS50-4 Compactors Oem Part 0177355 124 Mm Inner Diameter By 210 Mm Height Grey Housing

Direct Fit Rubber Bellows Boot For W Rammer Compactor 124Mm
✔️ Grey rubber boot covers 124 MM shaft diameter and stands 210 MM tall

This single pack grey rubber bellows works as a handy swap seal for W Rammer plate compactors and jumping jacks. It slides right over the piston rod to block gunk, dust, and creek water from sneaking into the crankcase during busy job site runs. The piece brings back tight compression so your rig pulls harder and burns less oil.

✅ Inner diameter measured at 124 mm with a 210 MM vertical profile
✅ Direct OEM fit for W Rammer BS500 BS50-2 and BS50-4 plate compactors
✅ Swaps out worn seals to stop oil leaks and keep dirt out of the engine
✅ Durable rubber compound resists cracking under daily vibration and heat
✅ Includes one single bellows ready to drop right onto existing hardware

💡 What keeps dirt and moisture from wrecking a plate compactor engine?

This housing acts as a handy gasket that shuts out road muck and standing water from tracking up the guide tube.

- Crankcase stays dry when the bellows clamps down tight over the shaft - Valve gears miss zero grit because of the slick 124 MM rubber lining - Torque holds steady so the footplate smashes clay flat without stalling - Dropping in a fresh sleeve saves you from pulling apart the motor later✝️