Pro Shop 0.4 Hp Right Angle Die Grinder Pulling A Massive 20000 Rpm Spin For Smooth Metal Tasks Featuring Rock Hard Aluminum Body Rear Air Bleed And Quick Swap Collets For Daily Fabrication Grind Jobs

Single Unit 20000rpm Pneumatic Right Angle Die Grinder
✔️ 0.4 hp motor, aluminum housing, rear exhaust, 6mm (1/4 inch) collet

This single piece right angle die grinder gets pushed by shop air to spin its tool holder fast enough for cutting, grinding, and polishing metals, plastics, and composites. Workers typically mount it on an air line with a hose to run it straight through tight spots, weld seams, and deburr parts inside factories, machine shops, and automotive repair bays.

✅ Zero point four horsepower pneumatic engine spins up to twenty thousand revolutions per minute
✅ Lightweight cast aluminum casing shrinks weight without sacrificing rigidity during rough cuts
✅ Rear exhaust system vents compressed air straight back away from your hands and workpiece
✅ Quick swap spindle takes a six millimeter rod plus a quarter inch shank so you can switch bits fast

💡 How much cubic feet per minute does a right angle pneumatic die grinder pull
To keep the tool handy and running smooth during long shifts, your compressor outfit needs to push clean, dry volume straight into the inlet port. Grab these tips before firing things up:
- Link a quarter inch hose rated for fifty CFM to stop the spindle from bogging down when you push hard against steel
- Drop a grease gun lubricator inline so fine oil coats the internal vanes and stops the shaft from seizing mid cut
- Swap old carbide burrs for fresh ones every other shift to keep chatter down and let the rotor spin free

✝️