Otc 1170 Two Jaw Pilot Bearing Puller For Removing Flywheel Bushings On Cars Trucks And Tractors With Slide Hammer Design Measuring Eighteen Inches Long Ideal For Light Duty Inside Pulling Tasks In Auto Repair Shops And Garages

Heavy Duty Single Pack Pilot Bearing Puller For Removal
✔️ Sixteen inch drive bar pairs with quick release jaws for fast swaps

This single unit slide hammer tool extracts stubborn pilot bearings and fabric rings from car, truck, and tractor drivelines. Mechanics run them through daily for clutch replacements and transmission teardowns in standard automotive shops.

✅ Fourteen ounce hammer head moves freely along hardened shaft guides
✅ Half to one and half inch jaw width grips tight tolerances without slip
✅ Three quarter inch reach slides past wide spacer collars easily
✅ Five twenty thread stud bolts right into mating faceplates securely

💡 How do mechanics choose a handy tool for stubborn bushing extraction jobs?

Shop floor cats swap these units for their no fuss design and straightforward loading mechanism. - Tough forged jaws snap onto seized seals instantly without grinding paint off cast iron - Roomy throat clearance handles fat axle housings and thick bellhouse flanges - Weighted slider drives pure kinetic energy to stuck parts so you walk away clean ✝️