Heavy Duty One Horsepower Ring Roller Pinch Bend Machine For One And Quarter Round Square Tube And Pipe Mild Steel Bending Rig That Knocks Out Tight Bends With Zero Sweat Powered By Three Phase Motor

Heavy duty single pack ring roller tube bender
✔️ 1HP three phase motor shapes half inch mild steel tube

This manual pinch bend rig is designed to form tight curves in metal stock without cracking or distortion. You will typically find it sitting on shop floors in fabrication shops, architectural metal studios, and HVAC duct manufacturing facilities where consistent radius bends are required.

✅ Maximum opening for round stock up to one inch quarter diameter
✅ Drives solid square tubing and flat bar with zero slip
✅ Runs on twenty two volt three phase power at sixty hertz
✅ Features sixteen hundred eighty RPM synchronous drive unit

💡 Why should a fabrication shop invest in a heavy duty pinch bend machine for metal tubing?
This handy setup kills material walk and keeps your radius spots dead lock.
- Align the upper pinch roller squarely against the lower support wheels to eliminate side load stress
- Feed the mild steel hollow section at a slow feed rate to maintain uniform wall thickness around corners
- Lock the quick release adjustment handles before engaging the main drive shaft to prevent kickback injuries