Heavy Duty Nitrogen Purge Boot Ditch Knuckle Busting Clamps For Smooth Brazing Purges Hands Free Regulator Seal Connects Universal ACR Tubing No Sweat Rig Setup

通常価格 77.77 セール価格120.0042.23の節約
Product ID: 1237-8117
UPC:





Heavy Duty Nitrogen Purge Boot Seals Copper Lines
✔️ Fits 3/8 to 1-1/8 inch o.d. acr piping for quick brazing setups

This single seal boot locks nitrogen pressure onto your refrigerant lines so you can braze joints without holding the hose. You get steady purge flow during air conditioning installations and field repairs.

✅ Orange rubber grip hooks your regulator tight while you solder copper tubes
✅ Works with every common coolant type and system oil you carry today
✅ Handles straight tube outer diameters from three eighths up to one inch eight
✅ Stays sealed at twenty psig max pressure for reliable gas delivery

💡 What is the proper way to install a copper line purge boot for brazing tasks?

A careful setup routine keeps your seal boot intact while you push dry nitrogen through the coil. You can keep your job site handy and stress free by sticking to these steps.
- Scrape copper surfaces smooth to stop sharp edges from cutting the inner gasket
- Confirm your tube falls inside the three eighths to one inch eight range
- Avoid forcing the boot onto bent or twisted pipe sections
- Hold steady gas flow under twenty pounds pressure to clear moisture completely

✝️