Heavy Duty Mechanical Limit Switch With Zero Lag Trigger And Thick 22AWG Three Pin Cable For Dead Nuts Reliable 3D Printer Endstop Upgrades Featuring Rock Solid Activation And Seamless Installation

通常価格 45.95 セール価格120.0074.05の節約
UPC:





Heavy duty limit switch for precise 3d printer axis triggers
✔️ Single switch packs 40x15mm body with 70cm sturdy three wire cord

This heavy duty mechanical limit switch snaps straight into your 3d printer frame. It acts as a reliable position sensor for your X Y and Z axes. You get a single ready to install unit that avoids messy soldering work. The direct plug design keeps your RAMPS or RepRap control board protected.

✅ Single pack contains one mechanical limit switch wired with a three pin lead
✅ seventy centimeter cord uses red VCC black GND and green SIGNAL strands
✅ heavy duty twenty two AWG copper core handles two amp current and three hundred volt spikes
✅ flexible casing measures forty mm by fifteen mm wide and ten mm deep
✅ heat resistant jacket stays secure during eighty degree Celsius runs

💡 Why choose a mechanical limit switch for accurate 3d printer axis detection?
Physical contact points prevent false triggers that delicate optical lenses cause. This rugged setup is straight handy for weekend builders swapping axes on the fly. - Heavy duty copper conductors carry consistent voltage straight to your mainboard connector
- Standardized three wire layout pairs perfectly with open source driver circuits
- Durable polymer housing shields internal pins from filament string and airborne particles
- Straight plug adapter eliminates messy crimping steps on any custom upgrade project

✝️