Heavy Duty M2 Steel Pilot Drill Bits, 5 Piece Set For Hole Saws, Knockout Center Guide Chuck That Goes Straight As An Arrow Through Wood Metal Steel And Plastic, Built Tough For Weekend Warrior Jobs

通常価格 39.99 セール価格80.0040.01の節約
Product ID: 1237-8136
UPC:





Heavy Duty Pilot Bits For Holesaws And Accurate Drilling
✔️ Five pack M2 steel set with 6mm shank works on 9/16 inch hole saws

You save hours aligning cutting rings because these center guide stubs snap directly onto any driver sized 9/16 inch or 14mm width or bigger. You get perfectly round openings through hardwood, PVC sheeting, cast iron waste lines, and thin stainless tubing without the saw walking off your layout marks.

✅ Reliable M2 steel construction drives through pressure lumber and galvanized pipe
✅ Shank size pairs 6mm or fifteen sixteenths inch width for secure arbor seating
✅ Overall reach tops out at 68mm or 2.67 inches for deep structural access every time
✅ Matte yellow finish resists workshop dust and sweat when packed in your tackle bag
✅ Minimum ring diameter hits 9/16 inch or 14.3mm for smooth concentric material removal

💡 What helps a pilot drill chuck stay straight while cutting tough metal pipes?
This little stub acts as a handy standoff so you never chase your layout lines when the drill spins up.
- Tough carbon steel stays rock solid under load and kills wobble before the first pass
- Three channel flutes spit chips quick to keep the cut face clean on rusted pipe
- Slim cylinder head drops right into standard arbors without hunting for extra bushings
- Pointy nose digs in firm and rides true through thick gauge plate when you hold it down

✝️