Heavy Duty Hydraulic Gear Puller With Adjustable Two And Three Jaw Plates For Easy Bearing Extraction And Shaft Removal Built Like A Tank For Daily Garage Grind Shop Approved Mechanic Must Have Kit

Single Heavy Duty Hydraulic Puller Set For Shaft Job Tasks
✔️ 5T tonnage rating covers 200mm cross pull plus 140mm shaft run

This single hydraulic bearing extractor delivers steady pushing force for yanking stuck pulleys, gears, and hub assemblies off machinery frames. Shops and auto garages lean on this adjustable tool set for routine maintenance, engine rebuilds, and heavy duty shaft swaps. The dual jaw head flexes to fit various load widths while keeping pressure locked during aggressive pulls. Mechanics grab this compact unit when tackling transmissions, air compressors, or motor mounts without marring delicate housings. ✅ Maximum hydraulic output reaches five tons for stubborn parts
✅ Transverse pulling capacity extends to two hundred millimeters
✅ Longitudinal draw stroke covers up to one hundred forty millimeters
✅ Thread diameter measures forty five millimeters for secure anchor setup
✅ Shaft center travel allows fifty millimeters of precise adjustment range

💡 What mechanical advantage setups handle tight clearance bearing removal most effectively? Picking a steady pull arrangement proves handy for residential workshops tackling frozen pulleys and worn hub assemblies without resorting to destructive prying methods. Technicians favor continuous hydraulic drive because it keeps lateral stress off delicate machined surfaces during high resistance lifts. - Seat the center screw against the shaft end to maintain straight force transfer throughout the extraction cycle - Widen or narrow jaw spacing until full inner race contact occurs for reliable torque multiplication - Monitor cylinder expansion rates to stop movement before thermal friction seals lock components in place - Clean mating flanges with solvent spray after each job to preserve sealing accuracy on future replacements

✝️