Dead On Z Axis Endstop Inductive Sensor For Three D Printers Built Like A Brick With Hassle Free Hookup For Tight Homing And Killer Precision On Every Saturday Morning Build
レビューはありません
タイトル
通常価格
68.95
セール価格166.0097.05の節約
UPC:
Single Unit Inductive Sensor For 3D Z Axis Setup
✔️ Heavy duty build. Fast homing calibration kit.
✅ Four wire leads plug straight into open loop boards to save time.
✅ Consistent trigger point locks layer heights so your models look sharp.
✔️ Heavy duty build. Fast homing calibration kit.
You get a single housing designed to mount directly onto the vertical rail. It sits right above the print bed so you never guess alignment. Makers install these on fdm units to prevent crash runs during overnight sessions.
P> ✅ Sealed metal face filters out dusty plastic so contacts stay clean.✅ Four wire leads plug straight into open loop boards to save time.
✅ Consistent trigger point locks layer heights so your models look sharp.
💡 Why pick an inductive Z axis homing switch for desktop 3d printers?
These solid state units stay handy during heavy print cycles.
- Stainless housing blocks oil buildup on linear rails.
- Trigger circuitry cuts motor power before hardware touches stopper plates.
- Wired layout routes clean signals back to main control boards.