3D Printer Bed Leveling Kit With Aluminum Hand Twist Nuts And Silicone Bed Spacers For No Fuss Easy Calibration On Popular Printer Lines Includes Four Leveling Nuts Four 18mm Mounts And One 16mm Mount

Kit with aluminum nuts and silicone for 3d printer bed leveling
✔️ 4 aluminum leveling nuts 4 18mm mounts 1 16mm mount

This kit gives you aluminum twist nuts plus silicone spacers to dial in the hot bed on common 3d printers without fighting springs.

✅ Aluminum hand twist nuts with 60mm outer M4 thread and 8mm thick
✅ High temp silicone mounts resist heat and absorb vibration
✅ Set has four 18mm mounts plus one 16mm mount for varied printers
✅ Works on Ender 3 Ender 5 and CR10 series except S4 and S5 models

💡 How do you get a flat first layer on a 3d printer? A level bed keeps the nozzle at the right distance across the whole surface so filament sticks evenly from edge to edge. - Use the aluminum twist nuts to raise or lower each corner in small turns while checking with a feeler gauge or paper test - Swap stock springs for the silicone spacers to hold the setting steady even after hours of heat cycles - Pick the right height spacer combo so all four corners reach the same tension without over compressing the bed - Check the center and corners again after the first test print and fine tune with the big easy grip nuts

✝️