Two Piece 1/8 Inch Thin Rip Push Block Table Saw Safety Jig Featuring Mounting Hardware And Solid Plastic Build Tailored For Killer Wood Stripping And Hassle Free Cuts So You Can Slice Thin Stock Like Butter Without Breaking A Sweat

Two Piece 1/8 In Thin Rip Table Saw Push Block Kit
✔️ Green plastic thin rip jig legs 180mm wide pack of two

This two piece set of thin rip push block extension legs bolts right onto your favorite safety sled or jig to keep digits far away from spinning blades while slicing stock down to an eighth of an inch. Local craftsmen and weekend DIYers swap these out for precision edge ripping, careful veneer matching, tight inlay routing, and clean decorative coves without worrying about kickback mess.

✅ Core rail length spans one hundred eighty millimeters by seven point zero nine inches with a two point one seven inch overhang profile
✅ Thickness gauge reads point six three millimeters deep or zero point zero two five inches to sit flush against wooden sled decks
✅ Mounting pocket opens to twelve millimeter wide channels and fits standard quarter inch hex wrench installations
✅ Weight distribution balances evenly at forty five grams or one point five nine ounces for smooth table feed movement

💡 What is a portable thin rip push block jig used for in busy woodworking workshops?
The primary function involves supporting narrow lumber strips during board ripping operations while keeping operator hands clear of rotating cutter heads.
- These handy attachments bolt directly to existing cedar sled platforms for consistent tracking alignment
- Wood grinders depend on them when feeding reclaimed maple planks through heavy duty jointers regularly
- Factory builders load them up alongside high tooth count kerf blades to slice cabinet grade plywood edges accurately

✝️