Tough As Nails 15 Ton Hydraulic Gear Puller Featuring Adjustable Two Or Three Jaws For Quick Wheel Bearing Separator Work Built From Heavy Duty Forged Steel So You Can Knock Out Garage Repairs Without Breaking A Sweat

Single 15 Ton Hydraulic Puller Kit For Fast Shaft Separation
✔️ Sturdy forged steel builds hold up to 15 tons pulling force easily

This hydraulic gear puller kit lets mechanics remove wheel bearings, pulleys, and gear assemblies without scoring metal surfaces. Designed for home garages and professional shops, the setup delivers steady pressure where pry bars fall short. You get reliable leverage that helps you knock out rusted parts fast during routine maintenance or heavy equipment overhauls.

✅ Heavy duty forged steel frame shrugs off bending under brutal loads
✅ Adjustable arms spread up to 12 inch (300 mm) wide for broad coverage
✅ Center screw travels 2 inch (50 mm) deep for steady extraction paths
✅ Maximum reach spans 7 inch (180 mm) out to grab larger diameter faces
✅ Swivel pump head spins 360 degrees for tight workspace access
✅ Balanced three leg design keeps tension centered on stubborn gears

💡 How do pros extract stuck hub rings without marring the axle?

Pumping a handy hydraulic separator takes the guesswork out of heavy lifting and keeps everything lined up true.

- Position the legs squarely on the outer race so pressure distributes evenly instead of twisting the metal

- Depress the handle gradually so the internal cylinder pushes until the part breaks free without sudden shocks

- Turn the whole unit horizontal or vertical to squeeze into cramped spots under vehicle chassis frames

- Lean on the integrated relief valve so we never crank past the factory rated capacity anyway

✝️