Threaded Spring Indexing Pin With Cross Handle Easy Pull Locator Plunger For Jigs And Automation Gear Bullseye Alignment Pin Built Tough For Zero Sweat Workflow Setup Integration

Heavy Duty Single Spring Indexing Pin For Custom Fixture Sets
✔️ M12 Carbon Steel Locator Plunger Pulls Back Fast And Snaps In

You get this single threaded locking pin to secure panels inside machining jigs and automation stations. Operators pull the easy cross handle to slide parts into position, let go, and watch the internal coil snap the locator dead center for handy repeatable runs that save you sweat on the shop floor.

✅ M12 steel core withstands heavy clamp pressure without bending
✅ Internal return spring pushes the locating tip forward on its own
✅ Compact bracket profile slips past adjacent bolts and rails

💡 What causes premature wear when mounting spring locator pins on aluminum fixture plates?

Spotting clean pilot holes and applying even torque prevents cross threading while the tough alloy casing takes repeated shock loads during daily production shifts.
- Countersink receiver holes slightly to guide the threaded barrel straight
- Coat the screw grooves with a film of dry lubricant to stop galling heat
- Press the flange flat against the substrate so vibration does not loosen the seat

✝️