Stainless Steel Chimney Support Bracket Kit For Pellet Stove And Water Heater Vent 475 Inch Diameter Built Like A Tank Roof Brace With No Sweat Setup And Rugged As Nails Weather Proof Durability
✔️ Steel brace secures vents 3.125 to 10 inches 80 to 255mm hits 120cm max span
This complete chimney support kit arrives ready to install inside your garage or workshop for home heating systems. You will find it ideal for stabilizing exhaust stacks on pellet stoves, gas furnaces, and water heaters where vibration control matters most. The adjustable bracket design keeps heavy ductwork aligned while protecting indoor air quality during cold months.
✅ Heavy grade stainless steel resists rust and handles winter wind loads without bending✅ Universal opening ring accepts vent tubing measuring 3.125 In 79.4 Mm to 10.0 In 254.0 Mm diameter
✅ Telescoping support pole stretches straight from 12.3 In 312 Mm out to 47.2 In 1200 Mm when fully extended
✅ Complete hardware pack lets you bolt the assembly directly to timber brick or concrete slabs
✅ Pre assembled frame drops into place and locks tight before the first fireplace use
💡 Why do insulated exhaust pipes require additional structural support near termination points? Dropping in a handy brace keeps the whole rig square so exhaust fumes dont backdraft down a cold basement hallway. - Rigid steel geometry absorbs thermal shock during rapid heat spikes while keeping gasketed joints tight against soot leakage paths - Wide footprint spreads heavy tube load across roof sheathing blocking water migration near fascia boards before rot sets in - Locked mounting holes hold flange spacing steady meeting inspector requirements without needing fancy tools or contractor help
✝️