Solid Stainless Steel Spring Plunger With M16x1.5 Thread And 8mm Pin Shaft And Top Notch Industrial Hardware Built To Take A Beating While Staying Locked In Place For Shop Projects

Heavy duty stainless spring plunger with M16 thread
✔️ M16 x 1.5 thread, 8mm (.31in) shaft, 24.5mm (.96in) length

This solid locking pin keeps workholding jigs, tooling plates, and automotive panels from shifting under heavy vibration or impact loads. The unit ships as a single ready to install piece, so you can mount it straight out of the box without extra hardware or fussy assembly steps.

✅ Rust resistant stainless coating handles wet shops and greasy environments
✅ Swivel pull ring gives full thirty six degree spin for comfortable hand access
✅ Standard M16 pitch engages cleanly into threaded inserts or tapped steel blocks
✅ Ground tenon measures 8mm (.31in) across while the body stretches to 24.5mm (.96in)

💡 What is the right way to mount a slide bolt locking pin on custom jigs? Most guys just drop the barrel into a drilled pocket and snug the provided nylon nut until the flange meets the surface flush. You can trust this straightforward approach by keeping a few practical tips in mind: - Double check the M16 metric thread pitch before cutting any mounting slots or holes - Keep the rear clearance gap wide enough so the push rod retracts fully inside the housing - Run a light coat of white lithium grease on the inner coil to stop early season squeaking - Polish the exterior grip regularly so the whole setup stays handy when speeds ramp up fast

✝️