Single Row Angular Contact Ball Bearing 25X62X17 mm 7305B Heavy Duty Steel Build Runs Smooth With Slick Low Friction Operation Built Tough For Demanding Gear Mods And Car Builds Engineered To Handle Heavy Loads Under Zero Stress

7305B Angular Contact Bearing for Heavy Load Applications
✔️ 25mm Bore x 62mm OD x 17mm Width Steel Cage 40 Degree Angle

You get one single row angular contact ball bearing designed to handle heavy radial and axial loads in automotive gearboxes and engine builds. The 40 degree contact angle keeps things spinning smooth while managing side forces that come off during hard shifts. Standard precision and a steel cage make this unit ready for tough jobs without extra fuss.

✅ Inner Diameter 25mm (0.9843 inches) fits 25 millimeter shafts ✅ Outer Diameter 62mm (2.4409 inches) matches standard housing bores ✅ Width 17mm (0.6693 inches) maintains tight assembly tolerances ✅ Mass 0.2233 kilograms balances strength against light weight needs ✅ Type S Steel Cage resists wear at higher rotational speeds ✅ 40 Degree Contact Angle maximizes capacity for axial loads ✅ Unsealed design allows custom grease options for specialized applications

💡 What makes single row angular contact bearings handy for gearbox and motor shaft alignment?

These angled internal geometry setups give you clear control over how side and forward forces travel through your drivetrain so you can dial in performance for custom builds.

• Different contact angles like 40 degrees allow you to swap in units that carry heavier thrust loads than standard deep groove types.
• Single row configurations keep space tight inside crowded housings where bulkier split designs just do not fit.
• Unsealed construction lets you run whatever lubricant matches your gear oil or special racing compound.