Pro Grade Heavy Duty Ultrasonic Cleaner With 30 Liter Heated Wash Tank And 600W Deep Soak Degreaser For Shop Parts And Medical Gear That Scrubs Grease Straight Off In Minutes Flat
✔️ 600W heater runs on 220V AC with adjustable 30 minute cycle dial
This heated ultrasonic degreaser acts as a deep soak parts washer for shops tackling oily engine blocks bike chains aerospace fittings and surgical instruments. The sturdy thirty liter stainless drum slides neatly onto any lab bench or garage workstation while the internal transducers work fast to strip away heavy grime without manual scrubbing.
✅ Inner stainless steel wash chamber measures 500 by 300 by 200 mm✅ Dual heaters and six hundred watt transducers operate at forty khz
✅ Electronic timer panel lets operators dial wash periods from zero to thirty minutes
✅ Outer housing spans 530 by 330 by 330 mm for compact shelf mounting
✅ Standard two hundred twenty to two hundred forty volt electrical hookup requires basic workshop outlets
💡 What drives an industrial ultrasonic cleaning system to remove baked on grease so handy around busy garages?
These units push sound waves through liquid solvent to create microscopic implosions that lift particles straight off solid metal. You save serious floor time when you pick the right heat and cycle duration for your batch weight. Run your maintenance tasks like a seasoned mechanic by following these proven steps:
- Fill the stainless reservoir up to the marked line so the transducer pads can shake free carbon deposits without straining
- Preset the thermostat to roughly forty degrees Celsius to melt thick chain lubricant before firing up the transducer array
- Watch the digital clock tick down between five and thirty minutes so you do not roast sensitive electronics during the deep soak phase
- Rinse the finished parts under fresh water immediately after cycling through to dodge hard water spotting and keep surfaces shiny