Plug And Play 6Pcs Vertical Tactile Travel Limit Switch For 3D Printer CNC Router Replacement Endstop Sensor With Rock Solid Performance And Hassle Free Install For 3018 Pro Models

Prezzo normale $49.99 Prezzo di vendita$100.00risparmiate $50,01
UPC:





6 Pack Limit Switches for 3D Printers and CNC Routers
✔️ 125V and 1A rating with 1m leads and open contact design

This six piece pack gives you solid vertical tactile limit switches to replace tired endstops on your 3018 Pro printer or CNC router. You snap them into the existing mounting slots and feed the included meter long cords straight to your control board. The normally open contacts stay clear until the moving axis trips the lever for a clean cut off signal.

✅ Normally open switch body that shuts the circuit when pressed ✅ Handles 125 volts and 1 amp steady current for stable motor stops ✅ Includes six matching one meter lead wires for fast bench routing ✅ Slots directly into 3018 MX3 and PROVer Mach3 frames without mods

💡 What are the main benefits of using plug and play limit switches for CNC routers?

These components keep your stepper motors from crashing into dead stops during long print runs.

- Normal open contacts trigger clean position signals to your motion controller immediately

- Meter long cords give you plenty of slack to snake wires through tight frames

- Six pack sizing means you always have backups handy when shop wear kicks in

✝️