Heavy Duty Workhorse Two Speed Corded Drill With 500 Watt Motor Handles Steel Up To Ten Millimeters With Ease And Delivers Serious Torque For Job Site Performance Built For Contractors And DIY Professionals Seeking Steady Power
Corded drill builds torque for contractors needing steady work
✔️ 500W motor, dual speeds, drills steel up to 10mm, weighs 2kg
This single unit two speed corded drill delivers reliable rotation for job sites where consistent output matters. It tackles routine metal drilling, woodworking layouts, and bolt prep tasks. Teams run it straight from heavy duty strips on construction floors and renovation benches.
✅ 500 watt absorbed motor pushes 270 watts of useful output to keep working rhythm intact under heavy loads
✅ Dual clutch range sets zero to seven hundred rotations per minute in first gear and zero to twenty two hundred fifty in second gear
✅ Adjustable torque control tops out at fifty newton meters stop force and supports tapping up to M10 thread sizes
✅ One three milimeter to thirteen milimeter keyed chuck grips bits securely while five meter cables reach distant work areas
| Material Capacity | Dimensione |
| Steel & Stainless | 10 mm (0.39 in) |
| Alluminio | 16 mm (0,63 in) |
| Wood | 35 mm (1.38 in) |
| Max Working Torque | 20 Nm / 7 Nm |
| No-Load Speed | 0-700 / 0-2,250 RPM |
| Chuck Opening | 1.5 mm (0.06 in) to 13 mm (0.51 in) |
💡 What is a two speed corded drill handy for when switching between different materials on an active jobsite?
The paired drive settings save time by matching rotation rate to material density instead of guessing a middle ground.
- Lower gear keeps high torque during starter cuts in steel while higher gear clears chips fast in softer metals
- Switching gears ahead of time cuts cycle counts and keeps crews moving smoothly through lumber and sheeting
- Operators get predictable feed pressure and less motor stall even when pushing through dense timber or hard alloys