Heavy Duty Stainless Steel Chimney Support Bracket Kit No Sweat Setup Roof Brace For 4.75 Inch Pellet Stove Water Heater Vent Pipes All Weather Resilient Design Built Tough As Nails

Single Pack Complete Stainless Steel Chimney Pipe Support Kit
✔️ Adjustable strut reaches 120 cm height, clamps tubes 8 to 254 mm wide

This full indoor and outdoor mounting system stabilizes exhaust lines for pellet stoves, gas heaters, and water tanks. The reinforced steel frame distributes heavy snow loads away from fragile joints, keeping ductwork aligned and safe throughout the year.

✅ All weather stainless steel frame holds ducting measuring 79 to 254 mm (3 1/8 to 10 inches) securely
✅ Vertical strut reaches heights up to 1199 mm (47.2 inches or 120 cm) depending on roof pitch
✅ Complete hardware pack enables floor wall or roof anchoring using masonry or wood screws
✅ Rated for diverse venting setups including boilers and drain lines across freezing conditions

💡 What is the best way to mount a heavy duty stove vent brace so it survives northern winter gusts?
The trick lies in locking the base plate solid before attaching the tube to the hoop. Here is the handy breakdown to keep your rig from drooping:
- Drive the anchor bolts through the footpad straight into solid decking or flashing
- Slip the ventilator pipe into the clamp and tighten the bolt until it grips cold
- Raise the support pole to shoulder height and wedge the pin to stop any wiggle room

✝️