Heavy Duty Double Station Milling Machine Vise Featuring Dual Workholding Stations For Simultaneous Metal Cutting Dead Nuts Accurate Steel Jaws Total Shop Floor Game Changer
✔️ 2.5 inch capacity, 4 inch wide jaws, 0.003 inch base parallel
This double station milling vise slots right onto your table or column to latch two blanks at once during heavy cuts. shop crews run these on vertical mills and drilling stations to swap out single part handling and keep chips flying faster than ever. you get a locked down setup that stays square even when you push hard on tough materials.
✅ dual setup grips separate pieces for faster cycle times through the mill✅ 2.6 inch throat clearance per side fits larger blanks and fixtures tight
✅ four inch wide contact surfaces spread clamp pressure evenly under load
✅ one point five inch jaw lift clears tall stock and deep step blocks
✅ zero point zero zero three inch bed runout keeps cut lines dead straight
✅ solid steel faceplates handle rough cuts without bending under pressure
✅ thick alloy bolts lock down tight so vibration never shifts your tolerance stack
💡 why use a double station machine vice for simultaneous part clamping on an industrial mill?
running two parts at the same clamp station cuts setup time and keeps your feed rates handy throughout the job.
- parallel machining paths reduce scrap rates by aligning both workpieces to the same spindle origin
- rigid block design stops flex when you push heavy chip loads through carbide tools
- adjustable base offset lets operators stagger cut depths without moving the whole rig
- heavy duty locking handles spread torque evenly across narrow shoulders and fragile edges