Heavy Duty Cast Iron Shallow Well Jet Pump With 3/4 HP Motor Pulling 16 GPM At 115 Or 230 Volt Giving Your Home A Straight Shooter Water System That Never Drops The Ball For Yards And Barns

Reliable Shallow Well Jet Pump Delivers Steady Home Water
✔️ 3/4 HP engine pulls sixteen GPM on 115 230 volt cast iron models

This unit functions as a robust shallow well jet pump built to transfer fresh water from depths reaching twenty five feet downward. Contractors install it for feeding supply lines across rural cabins, livestock barns, garden irrigation grids, and detached workshop buildings. The tough outer shell shields internal mechanisms from dust and moisture while keeping liquid flowing steadily through outdoor plumbing setups.

✅ Three quarter horsepower engine moves sixteen gallons per minute
✅ One point two five inch FNPT intake handles heavy suction pull
✅ Single inch FNPT outlet ports connect directly to yard hose lines
✅ Sixty five PSI max rating supports deep residential well setups
✅ Factory calibrated thirty fifty switch controls tank cycling automatically
✅ CSA approved wiring meets North American safety codes strictly

💡 What is the best way to wire a shallow well jet pump for consistent backyard water pressure?
Hooking things up proves pretty handy once you sort out the voltage selector on the motor coil.
Match your house wiring to the terminal strip before securing connections inside the drip resistant control box.
Run fresh cables through heavy duty conduit sleeves near the footer slab to keep soil moisture out.
- Connect twelve gauge conductors to the one hundred fifteen volt starter terminals
- Secure neutral bus bars under rubber grommets above the drainage pan
- Bond all iron pipe fittings to the utility ground rod with copper clamps
- Verify compressor amp draw stays under breaker limits during peak season heat