Heavy Duty Badass Hydraulic Gear Puller Kit With Two Or Three Jaw Bearing Separator For Horizontal Vertical Brake Drum Hub Extraction Using Quenched Forged Steel Ejector Pin

Heavy Duty Hydraulic Gear Puller Kit Set For Seized Bearings
✔️ 30 ton rating paired with 5 cm stroke and 40 cm jaw spread

This single complete kit set functions as a precision bearing separator designed for pulling brake drums, hub assemblies, pulleys, and gear shafts in busy auto shops and industrial workshops. Its rugged forged steel frame and seamlessly molded pump housing handle horizontal or vertical positioning without cylinder cracking or oil leaks during extended shop floor cycles.

✅ Complete hardware package includes replaceable pulling arms rated for thirty ton extraction loads
✅ High temperature ejector pin pushes forward two inches or fifty mm to bite deep into grooved hubs
✅ Primary linkage stroke travels seven point eight inches or one hundred ninety eight mm per cycle
✅ Clamp reach widens up to fifteen point seven inches or three hundred ninety eight mm for wide rims
✅ Smooth turning pump head spins three hundred sixty degrees around cracked piston bores

💡 How does a heavy duty hydraulic puller extract warped brake drums without marring fragile hub faces?
The system works by converting manual lever action into constant push force while keeping all contact points square against stubborn metal rings.
- Quenched forged center pins extend two inches or fifty mm to sit flush against hidden axle sleeves
- Rigid stamped alloy claws clamp tightly around cast iron pulleys leaving zero scoring marks on machined journal surfaces
- Integrated hydraulic circuits hold steady pressure during slow rotation cycles so worn bearings slide straight off main shafts