Heavy Duty 4 To 8 Inch Flexible Duct Collector Arm Featuring Slick Articulated Fume Extractor Hose For Welding Laser And Soldering With Removable Stainless Steel Hood That Keeps Your Workshop Air Fresh As A Daisy While Crushing Dust Like A Bad Ass Rig
✔️ Gray plastic tube withstands ninety C heat plus three steel hood options
This heavy duty duct collector arm connects directly to your primary extraction system to route sawdust, smoke, and soldering fumes away from your breathing zone. Machine shop mechanics and woodworkers install them under bench edges to maintain clean indoor air without choking their central vacuums.
✅ Heavy gauge plastic liner stays flexible down to minus twenty five C and holds up to ninety C✅ Three to one compression ratio lets you bend the tube past corners without choking airflow
✅ Swap out the catch pans quickly using the one hundred sixteen and two hundred millimeter hood sizes
✅ Built in slide gate valves seal off unused arms so pressure stays locked on active stations
💡 Why do custom ventilation setups rely on sliding duct collectors to balance static pressure across different workstations?
Hooking this handy piece of gear straight onto your main blower keeps the airflow steady while dodging awkward bends.
- Routing the arm past grinding disks catches heavy swarf before it clumps up your HEPA cartridge
- Dropping it beside a laser table locks in suction velocity so delicate acrylic sheets dont melt from backflow
- Adjusting the internal baffle plate shifts power where you need it most without killing overall volume