Built Tough Tile Chamfering Machine Featuring A 1200W Corded Motor And Splash Free Cooling System For Quick 43 Degree Cutting At 13000RPM No Sweat Beveling Edger That Runs Like A Champ And Gets It Done Daily

Heavy Duty 43 Degree Tile Beveler With 1200W Motor
✔️ 1200W chamfer tool spins at 13000RPM with liquid cooling

This single tile chamfering machine is a handheld edger built for removing sharp corners and creating angled profiles on ceramic, porcelain, and stone tiles for countertops, backsplashes, and shower surrounds.

✅ 1200W motor reaches 13000 RPM rotation without stress
✅ 43 degree fence aligns blades from 116 mm to 4.57 inches wide
✅ Water pump feeds fluid across a 3.8 meter to 380 centimeter hose that spans 12.47 feet
✅ Aluminum and nylon chassis measures 25 cm long and weighs 5.9 kg or 13 pounds

💡 What is the proper way to wire and run a tile chamfering machine during a countertop remodel?

This handy tool gets the job done without fuss when you hook it up right.
- Plug the corded unit into a standard 110 volt circuit and secure the diamond blade onto the 12 mm drive shaft
- Connect the 12 volt cooling pump and lay out the 3.8 meter cable so the water mist hits the cut zone immediately
- Hold the three rubberized grips tight, release the safety latch, and drag the slab forward at a steady rhythm
- Monitor the coolant flow until the groove clears so heat stays low and the edge comes out chip free✝️