Boss Level 1 2 Hp Circulation Pump Ups26 150Sf With Plug And Play Hookup For Grundfos 95906632 Units Three Speed Settings For Dependable Hydronic Heating And Cooling You Can Lean On

1 2 Hp Circulation Pump With 3 Speeds For Hydronic Heating Replacement
✔️ 115V 1 2 HP With 3 Speeds And 2 Bolt Flange For Hot Water Pump Replacement

You can snap this single 1/2 HP circulation pump into your hydronic heating or hot water loop right away. It swaps directly for Grundfos units UPS26-150F so you do not waste time hunting parts. The sealed canned rotor keeps bearing grease safe while the cast iron body takes a beating. Get reliable heat delivery without calling a plumber every week.

✅ 3 Switchable Speed Levels Adjust Draw From 265 Watts Up To 370 Watts As Needed
✅ Rated Flow Hits 26.9 Gallons Per Minute For Steady Indoor Heat Distribution
✅ Delivers Rated Lift Of 25.4 Feet 7.7 Meters At Top Efficiency Point On Curve
✅ Boosts Water Up To 45.3 Feet 13.8 Meters Vertical Head During Peak Demand
✅ 2 Bolt Flanged Ports Span 6.5 Inches 165 Millimeters Center To Center Flat
✅ Cast Iron Housing Resists Rust And Corrosion After Years Of Continuous Run Time
✅ Handles Potable Water Temperatures Between 36 And 230 Degrees Fahrenheit

💡 What Advantages Does A Sealed Canned Rotor Design Offer Compared To Open Shaft Circulators?
You get a maintenance-light swap that locks leaks out tight while keeping noise down low.

• The closed can isolates the rotor chamber so gaskets hold back sludge better over time.
• Self-aligning bushings ride the pumped liquid stream to cut friction noise during burn cycles.
• Simplified mounting boards let you fit this unit between tight studs without twisting pipes around corners.
• Dry operation logic prevents vapor lock buildup that chokes flow when you crank the thermostat up high.

✝️