Tough Boss 1/6 Hp Machine Tool Coolant Pump 3 Phase 220/440V Lathe Bandsaw Oil Cooler No Sweat Circulation System Gutsy High Flow Performance Built Like A Train For Shop Use

Heavy duty machine coolant pump for workshop lathes
✔️ 1/6 hp motor drives 3 phase 220 440v shop cooling systems

This machine tool coolant pump moves cutting fluids efficiently through machining setups without fuss. You run it from the tank of a lathe, milling machine, or bandsaw to keep the work area cool and lubricated during heavy cuts.

✅ Immersion depth measures 180 mm and 7 inches from plate to base
✅ Discharge port uses 12 mm and 12 inch NPT threading for secure pipes
✅ Output speed hits 47 L and 12 4 gal per minute under sixty hertz push
✅ Vertical lift beats 5 4 m and 17 7 ft head pressure against seven psi drag

💡 What technical factors determine if a three phase immersion cooler works reliably for industrial metal cutting?

Picking the right pump comes down to checking your facility amperage feed and ensuring the winding matches your main line voltage. Here is why getting those numbers right makes the whole setup super handy for busy shop floors:

- Sealed ball bearing assemblies block abrasive chips from wearing down the wet end while you grind hard metals

- Ceramic insulated windings take heat spikes without cooking the coil on standard twenty two volt circuits

- The linear slide unit mount keeps the motor shaft dead center so you skip constant realignment after service calls

- Sixty hertz drive cycles deliver max water velocity through tight filter housings without choking the suction line