Solid Router Template Bushing Guide Set With Nine Sizes Fits All Porter Cable Sub Bases A Total Game Changer For Dedicated Woodworkers Craving Flawless Cuts Daily
✔️ 8 zinc plated rings and dual locknuts plus centering cone
This complete routing accessory bundle delivers eight solid metal template rings spanning a quarter to an inch width, followed by twin retention nuts, a rugged carry case, and a steel alignment pin paired with an ABS plastic marker cone. Shop builders tap this rig for flush trimming, door frame sizing, hinge recesses, and rapid sub base swapping on standard wood routers and handheld power tools.
✅ Router sub base plate compatible under 44mm centers including DeWalt Craftsman Bosch Milwaukee and Makita mounts✅ Precision cutting guides feature tight internal threads and smooth bearing tracks for clean MDF template routing passes
✅ Half inch router bushing series pairs naturally with standard collet setups while smaller sleeves handle detailed edge profiles
✅ Aluminum router accessory build resists warping and keeps consistent diameter tolerance across repeated hot shop sessions
💡 How does a router base plate centering pin improve template routing accuracy?
Using a dedicated alignment tool removes guesswork and keeps your cutter perfectly matched to the bearing path every time you switch templates.
- Drop the matching cone end into the spinning collet to instantly establish a true centerline on any standard sub base mount
- Slide the guide ring inward or outward until it rests against the marker then tighten your hardware for zero drift
- Keep this handy adjustment kit near your bench to swap plates fast between dovetail stops and flush trim passes
- Match the quarter and half inch pin ends to different bit shanks so your setup stays tight across varying cutting depths