Shop Floor Approved Aluminum Vise Jaws With Offset Build Designed To Hold Firm At 5 1/2 Inches Wide And 3 Inch Center Spacing Plays Nice With Craftsman Columbian Fuller Gear Easy Bench Swap Replacements

Set of two aluminum vise jaw replacements for busy workshop benches
✔️ 5.5 inch face width, 0.75 inch height, 3 inch center spacing

The two piece kit slides right over tired jaw faces on standard bench vises. Built from tough aluminum alloy, these handy pads stop surface marring while handling serious bite during routing, drilling, or fixture work. Mechanics pop them in fast when factory grips lose their hold.

✅ Aluminum body prevents warping under serious clamping forces
✅ Face width measures five and a half inches for full project support
✅ Mounting holes sit three inches apart center to center
✅ Kit ships with four low profile hex head fasteners ready to tighten

💡 What diameter drill bit properly expands standard bench vise mounting pockets for aftermarket jaws? Restoring proper clamp geometry demands precise hole alignment and correct thread engagement. Match your tool selection to existing tap sizes to guarantee secure anchor points. - Select a seven thirty second inch twist bit to safely enlarge cast iron ports - Align the drill perpendicular to the base plate to prevent angled insertion - Torque the included allen bolts evenly to avoid stripping soft aluminum threads

✝️