Mt2 Hardened Tungsten Steel Half Notched Dead Center 60 Degree Morse Taper 2mt Tailstock Support Rock Solid Lathe Accessory For Woodworking And Precision Turning

MT2 Tungsten Steel Half Notched Dead Center 60°
✔️ Tungsten steel MT2 taper 60° tip HRC40-45 100mm OAL 17.8mm dia

This single MT2 half-notched dead center is a sturdy lathe fixture made from tough tungsten steel. Built for toolboxes, garages, and machine shops, this 60-degree tailstock prop holds wavy stock firm while you tackle precision turning, grinding, milling, and drilling tasks.

✅ Made from tough tungsten steel rated HRC 40-45 for extended tool life. ✅ Sharp 60-degree point yields clean hit marks with 0.01mm accuracy tolerance. ✅ 100mm 3.93-inch overall drop length seats deep inside standard MT2 sockets. ✅ 64mm 2.52-inch rod stem slides cleanly without binding in tapered bores. ✅ 32mm 1.26-inch high half-notch clears tall stock and stops rubbing friction. ✅ 17.78mm 0.7-inch max shaft diameter handles heavy loads with zero whip. ✅ Light 0.14kg 5-ounce weight keeps manual loading quick and hassle-free.

💡 What makes a half notched dead center better than a full center for center drilling?
- Extra flank space stops chips from wedging up against the workpiece edge.
- Flat side clearance lets you run center drills right into the material face.
- Full point strength still handles radial loads during rough cutting phases.
- Handy swap-in unit cuts setup time since no special fixtures are needed.

✝️