Kickass 3D Printer Upgrade Extension Cable Kit For X Y Z E Axis Motors Limit Switches Filament Detector Cables One Meter Long Dead Reliable Plug N Play Compatibility With Ender 3 Pro CR 10 Series Machines
Sin comentarios
Título
Precio habitual
59.95
Precio de oferta149.00Ahorras89.05
UPC:
Pack five upgrade cable set for 3d printer motor boards
✔️ One meter length wire kit for axis drives and sensor loops
✅ Measures one thousand millimeters to thirty nine point three seven inches for exact routing
✅ Snaps directly onto standard twenty pin control boards
✅ Holds up to repeated heating cycles inside active chambers
✔️ One meter length wire kit for axis drives and sensor loops
You typically use this set of five adapters to restore clean signals to stepper motors and filament runners on desktop fabrication frames. Mount the fresh harnesses along your gantry rails and resume crisp layer adhesion instantly.
✅ Includes separate leads covering every axis and runout reader✅ Measures one thousand millimeters to thirty nine point three seven inches for exact routing
✅ Snaps directly onto standard twenty pin control boards
✅ Holds up to repeated heating cycles inside active chambers
💡 What causes intermittent motion loss on open frame printers?
Factory wires degrade fast from heat cycling and pull too much amps driving stepper coils. Swapping in heavier gage leads restores strong pulses and locks layers down tight.
- Align the socket tabs before pushing the plugs into the driver
- Route the fresh strands behind the heat shield to dodge radiant warmth
- Test the resistance with a basic meter to confirm zero slack
- Run a quick calibration sketch with paper clips loaded to spot wobbles
Compartir
Opiniones de los clientes
Be el primero en escribir una opinión
0%
(0)
0%
(0)
0%
(0)
0%
(0)
0%
(0)