Heavy Duty Split Hydraulic Gear Puller Built Tough As Nails Featuring R2 3/8 Connector And Configurable Two Or Three Jaw Designs For Wheel Bearings Handles Sixty Six Thousand Pounds Runs Slick

Heavy duty split hydraulic gear puller for factory rigs
✔️ 2 3 replaceable jaw config for precise bearing extraction

This split hydraulic bearing extractor delivers consistent force for removing stubborn shaft components like wheels, bushings, and sprockets across mining, rail yard, and workshop bays. Unlike manual screw pullers, it plugs straight into a standard hydraulic pump to lift or push loads without bending fingers or cracking cast iron.

✅ Forged alloy steel frame handles 30 tons without flexing
✅ R2 38 adapter fits standard pumps and caps against dust ingress
✅ Converts between twin and triple jaw setups for odd shaped rims
✅ Hardened push rod moves up to 70 millimeters or 2.7 inches per cycle
✅ Compact storage case measures 320 by 160 by 160 millimeters or 12.6 by 6.3 by 6.3 inches

💡 What makes a rugged hydraulic gear splitter safer than hand operated models Fluid power transfers straight through the forged body without creating pinching hazards at your knuckles. - Pump the attachment handle to generate even tension across warped raceways - Release quick safety valves when dropping loaded components onto sturdy blocks - Swap out replacement claws rapidly to match inner ring diameters without wrenches - Keep the rig handy around tight engine bays and worksite floors