Heavy Duty Pneumatic Cement Spray Gun For Walls Features Four Precision Nozzles That Deliver Smooth Plaster Fast Cuts The Grunt Work And Turns Daily Job Site Hustle Into Rock Solid Pro Finishes Without Breaking A Sweat

Heavy Duty Pneumatic Cement Spray Gun For Wall Plastering.
✔️ Aluminum iron shell, 3.5L tank, 8bar pressure, four nozzles, heavy duty.

This single pack pneumatic cement spray gun takes the sweat out of covering big walls with mortar or plaster by running off compressed air. Contractors and renovators hook this handy unit to a shop compressor to blast smooth layers fast while handling site grit without crushing their arms. The rugged build keeps up with daily hustle so you get pro results without the manual backbreaking grind.

• ✅ Four nozzle pattern lays down consistent texture across wide wall spans while managing 770×225×210 mm / 30.31×8.86×8.27 inches overall tool footprint
  
• ✅ Electroplated aluminum and iron chassis fights rust and impact damage while weighing just 2150 g / 2.15 kg / 4.74 lbs
  
• ✅ 3500 ml / 3.5 L / 118.35 oz bin holds plenty of material to slash refill stops and measures 340×245×200 mm / 13.39×9.65×7.87 inches packed
  
• ✅ Ergonomic dual handles lock in steady control and lift support since squeezing solo triggers causes fatigue during long shifts
  
• ✅ Runs clean at 8bar working pressure using the 1/2 inlet port and flows best with compressors pushing above 2600W power levels
  
• ✅ Quick water flush wipes away residue from the smooth inner surfaces after every run to keep spray holes clear for next time
  
• ✅ Assembles easily with included hardware and manual plus requires no electricity since pneumatics run straight from air hoses
  

💡 How to set up and maintain a pneumatic cement spray gun for optimal wall coating results?
M Maintaining crisp airflow and flushing out slurry keeps this spray tool performing at top speed on tough renovation gigs. Match your compressor settings to pressure demands and rinse the barrel immediately to avoid dried mortar gumming up the mechanism. Store the unit in a dry spot between seasons so moisture doesnt corrode the fittings. Double-check seal rings and couplings monthly since dust exposure wears seals faster on gritty job sites.

• Verify the compressor delivers sustained flow above 2600W to hit the 8bar target pressure without stalling mid-pass
  
• Flush the aluminum barrel and four-hole tips with fresh water right after spraying so leftover plaster doesnt harden inside the passages
  
• Lubricate the trigger springs and wipe the electroplated exterior to preserve smooth operation and prevent surface scratches over time
  
• Inspect the 1/2 inlet hose coupling for leaks since loose connections waste compressor energy and ruin spray consistency on uneven walls