Heavy Duty One Ten Scale RC Servo Featuring All Metal Gears Twelve KG High Torque Digital Motor Built For RC Cars And Boats With Lightning Fast Response And Rock Solid Ride Ready Design

High Torque Metal Gear RC Steering Servo Single Pack Sold
✔️ 12kg grip uses all metal gears dual bearings plus solid shell

This heavy duty digital servo drives precise steering and throttle control on 1/10 scale rc cars boats and planes. Its robust all metal gear train handles rapid impacts while delivering steady power during tight turns or fast launches. Riders swap to this unit when their old steering actuator struggles with heavy mods or competitive racing demands. The standard jr connector drops right into most receiver modules without extra adapters.

✅ 12 kg.cm stall torque at six volts for serious pulling power
✅ 0.09 second response per sixty degrees at six volts for quick direction changes
✅ Dual ball bearing setup keeps internals aligned under heavy side loads
✅ Sturdy metal shell blocks electrical noise and shields gears from dust
✅ Full hardware set mounts directly to standard chassis frames

💡 Why do racers upgrade to high output metal gear servos for off road trucks and boats?
- These handy steering actuators cut signal lag and handle sudden impacts much better than plastic internals
- All metal gear sets spread load across stronger teeth which stops stripped cogs during hard drifts
- Dual sealed ball bearings take lateral force away from the shaft so your linkages stay tight over long runs
- Standard pulse width signals work straight through modern receivers without needing voltage converters or rewiring