Heavy Duty Metalworking Downdraft Table Featuring Dual Motors And Killer 3700 Cfm Airflow Seamless Industrial Welding And Grinding Station For Easy Shop Cleanup Tough Badass Dust Control Daily

Industrial metalworking downdraft table dual motor 3700CFM one pack
✔️ Dual 3/4 HP motors provide 3,700 CFM filtration over 61X23IN table

This heavy duty metalworking downdraft table brings serious cleanup power to your welding and grinding setup. Built with dual motors, it pulls dusty metal shavings and debris right through the flat steel top so your shop floor stays dry and safe. You get a massive load capacity of 440 pounds, meaning you can park big parts or heavy fixtures on the bench without worrying about stress damage.

✅ Table surface measures 61" x 23-1/2" (1524 mm x 584 mm) for ample workspace
✅ Supports up to 440 lbs (200 kg) load capacity across the solid metal deck
✅ Runs on dual 3/4 HP (0.55 kW) single-phase motors at 110 volts for power
✅ Delivers 3,700 CFM air extraction with four 300 micron replaceable filters
✅ Overall footprint is 64-1/2" x 24-1/2" x 34-1/2" (1638 mm x 622 mm x 876 mm)
✅ Ships with two removable dust drawers sized 19" x 11" x 3-1/2" (483 mm x 279 mm x 89 mm)
✅ Noise level stays under 78 dB while maintaining steady suction performance

💡 How do you properly install a downdraft table to ensure effective dust collection during metal fabrication tasks?
Getting this metalworking vacuum box set up correctly is a handy way to keep your breathing zone clean and extend filter life significantly.

• Position the unit against a wall or on a stable concrete pad away from foot traffic to maximize intake clearance
• Connect the exhaust port directly to your main ducting or outdoor venting path to move hot smoke and sparks safely outside
• Inspect the sealed access doors and latch hardware before operation to guarantee full downward suction across the entire grate
• Run a daily debris check and empty the collector bins before the drum reaches maximum volume to maintain peak airflow rates